Good evening everyone, I know it's Christmas and it's a long shot but I'm in need of course sandpaper. Im working on my drain line and need more course paper to sand it down. Anyone near Conyers that can help out please and thank you.
50/60 grit sandpaper near Conyers
- Thread starter Reefchef
- Start date
If you are just wanting to smooth the end where it's cut you can slide it back and forth on concrete, it works well.
I actually cut out the red sea valve and finally put in a spears gate valve to quiet this thing up. So I had to cut it and sand down the metric fitting to fit my 1 inch union. I finally got it but it took a while and a bit of elbow grease using 150 grit! I couldn't keep my water level consistent with that red sea valve, especially after cutting off the pumps for feeding. Thank you for the tip though.
Did that help with the gurgling?
Yes, plus it helped maintain a constant level. I was having a problem with the water level going up and down when the pumps came back on. That in return made it hard to maintain proper salinity. Because when the pumps would come on, it would raise the water level in the tank and the ato would compensate by adding more water in the sump.
Yeah I remember when I came over it was gurgling really bad. So I'm glad you found a solution.
Similar threads
