AI sol Placement.
- Thread starter jc_k
- Start date
I have mounted them over several tanks. The best way I've found to do it is to have ledger boards attached inside your canopy at the height you want and use their rail to mount & span across those ledger boards (pic attached). Makes adjustment front to back on the ledger boards and between the AI units (left to right) sliding on the rail easy.
If you are running without a canopy, I've mounted from the ceiling. Either DIY or their hanging kit.
alt="" />
If you are running without a canopy, I've mounted from the ceiling. Either DIY or their hanging kit.
Sorry for hijacking!
Jhon, now that I see your return I believe that I need to copy your set up. I have two returns on the corners of the tank want to get the "Y" that you have after the valve, before the "45's", just to reduce the pressure on the pump for the return, instead of using a "T" the 2 "90's" for the same purpose.
Where do I get that Y?
Thank you again!
:hijacked:
Jhon, now that I see your return I believe that I need to copy your set up. I have two returns on the corners of the tank want to get the "Y" that you have after the valve, before the "45's", just to reduce the pressure on the pump for the return, instead of using a "T" the 2 "90's" for the same purpose.
Where do I get that Y?
Thank you again!
:hijacked:
Glass shouldn't impact the spectrum of the AI Sols, but I'm personally not a big fan of glass tops. Glass generally limits gas exchange and traps heat (probably not much of an issue for most of us right now though, but will be in a couple months). I'd recommend using a mesh top - pretty easy DIY.
