Rebuilding my mp10

[superclown]

Hey guys its been a while but I finally got around to replacing bearings in my mp10 yesterday.

Upon removal I found a bunch of loose black metal shims.. I'm thinking these came off the old bearings ?


I ended up using the cheaper 6.00 rubber sealed bearings so far pump is super quiet.

However I am having one issue the magnetic plate is rubbing up against the cover on the inside. Making a slight clicking noise. I've reassembled it twice now to see if I didn't tighten something down right but it still rubs ???
Has anyone else had this issue before ?

sent from old rotary phone using tapatalk

 

[joseayes]

Those shims that you talking about prevent the magnetic shaft from sliding on both sides, they should be installed on the shaft axle to avoid that, I don't know if I took pic of it on my replacement but I gonna look for the thread. Could be the shaft winding from one side to the other
Look for pic #11

 

[superclown]

OK I will go check it out thanks

Sent from my DROID RAZR using Tapatalk