RODI install
- Thread starter wantsummora acropora
- Start date
Awesome! Do you know the manufacturer of the fitting? I want to make sure it is resistant to salt water corrosion.
but it will never see salt water
As stated it will never see salt water, as your only providing fresh water to your rodi unit. But shark bite is the manufacturer, it's really nice and convenient because it's simply a push connect fitting so you don't have to worry about crimping or anything. If you do happen to go with the shark bite fighting don't forget the little plastic tool used to remove it, its like $1 or 2 but you will kick yourself if you need it and don't have it!
Nice! Thank you, I was nervous about cutting into my water supply.
- Messages
- 639
- Reaction score
- 627
Can I see where your waste water drains to?
Its all about your location, mine isn't the prettiest but it works! I just run the tubing along the floor in my garage and under the door to the outside. Is your laundry room near by or a sink that you can use a drain saddle or something like that.
- Messages
- 474
- Reaction score
- 419
Just run tubing to drain pipe your washer drains into. Small tubing should fit fine. Zip tie to washer drain line to hold in place. Just my thoughts if possible as I don't know your layout.
Sent from my SM-N975U using Tapatalk
Sent from my SM-N975U using Tapatalk
All I have is the drain line in the above picture. I'm nervous about tapping into it too. I'm in the basement and below sewer level so its on a pump. A check valve should do...I guess.
