Here is something I made in about 5 minutes. Seen setups like it for $10 at FosterSmith etc. Most Reefers have this stuff laying around.
Pic 1:
Rigid 1/4" OD sirline tubing. Buy for $1.50 at Petsmart if you need to source it. I used a 15" length of it.
Pic 2:
Heat the area you wish to bend at a stove or wherever. Don't put the tubing right in the flame, just enough to where it starts to bend. My bend has a width of 1.75", enough to make it over all standard tank trim, but works on rimless tanks as well. Hold the bend in place until the tube cools and stiffens.
Pic 3:
Finished tubing.
Pic 4:
Attach a length of airline tubing and a cheapo airline valve and you are done.
<fieldset class="gc-fieldset">
<legend> Attached files </legend>
>
class="gc-images" title="drip1.jpg[/IMG] style="max-width:300px" /></a>
>
class="gc-images" title="drip2.jpg[/IMG] style="max-width:300px" /></a>
>
class="gc-images" title="drip3.jpg[/IMG] style="max-width:300px" /></a>
Pic 1:
Rigid 1/4" OD sirline tubing. Buy for $1.50 at Petsmart if you need to source it. I used a 15" length of it.
Pic 2:
Heat the area you wish to bend at a stove or wherever. Don't put the tubing right in the flame, just enough to where it starts to bend. My bend has a width of 1.75", enough to make it over all standard tank trim, but works on rimless tanks as well. Hold the bend in place until the tube cools and stiffens.
Pic 3:
Finished tubing.
Pic 4:
Attach a length of airline tubing and a cheapo airline valve and you are done.
<fieldset class="gc-fieldset">
<legend> Attached files </legend>