So I fixed my plumbing, now I have a new problem

[bdesper311]

As some of you know, I bought a CADlight tank after reading a lot of good stuff about them, well everything that can go wrong on this tank has at some point. Long story short after several shipping issuse, some missing parts, and a plmbing nightmare, i have water in my tank! :thumbs: The new problem however is that my pump that comes with the tank is pumping water into the tank faster than it can come down the overflow into the sump. this is my first tank with a sump in it, so I don't know how to keep the water in my sump longer. When I added more water, it didn't help. My durso has a hole drilled in the top, but it is covered with water now. I put in a piece of airline tubing into the hole to allow more air, but it did not do anything, maybe because iy was not airtight? Any suggestions on how to fix this?

 

[bdesper311]

that is part of the problem, i bought it as a whole setup so it came with some no name pump... here is the link for the tank

 

[bdesper311]

it says that, but it did not come with one... the problem is, it uses those flexible tubes, so what would I do about a ball valve? I hate this company!!! should i think about getting a new pump, which one? should I hard plumb?