Anyone have a hammerhead or near equivalent handy?

[saltwaterwannabe]

Apex reported my temps and ph dropping like a rock on my way back home from vacation. I assumed it was the gfi acting up, but sad to say the main system pump is covered in salt and not turning. I am about to disassemble it to see if I can get it working but am afraid I will break the seals like I did on my spare.

I hope I do not need it, but thought I would ask before everyone else to to bed. Anyone have a spare hammerhead or similar pump lying around?

 

[saltwaterwannabe]

Pump does not work after gentle cleaning. Going to disassemble...wish me luck

 

[saltwaterwannabe]

Got it moving water again! The outlet on the apex may be acting up though.

 

[saltwaterwannabe]

This makes two apexes that have done the same thing to me. The hammerhead has been on the same outlet for at least a year without issue. Now none of the outlets will run the hammerhead but the wall outlet will. Is there a calibration, fuse, or something I should be aware of with the apex?

 

[ichthyoid]

The Apex outlets are current limited.
Two of the outlets are relay switched for higher current, so be sure you use one for the Hammerhead.
Do you know how much current draw you are pulling with the Hammerhead Dan?
See page #4 in the manual for the EB8 -

https://www.neptunesystems.com/downloads/docs/EB8_manual.pdf