APEX and CA RX setup

[snowmansnow]

ok, probe is finally calibrated all good there.

Since I'm new to Apex UI is this correct?

Control type : pH Control
Icon:

pH control setup
Fallback (on/off) : Off
Probe name : pH
High value : 06.65
Low value : 6.00
On when : High

_______

really the high value is all that matters right?

Thanks for advice / input

B.

Edit: ok.. so in watching it.. I need to put the Low Value to 06.60 to make the hyst .05 right?

 

[chony]

Following. I'm about to set mine up as well.

 

[cantare00]

barry_keith;921929 wrote: Looks good to me. I would set high around 6.65 - 6.70 and low at 6.60 for the reactors pH probe. Do you have a full apex, two pH ports? If so also set the probe your sump / tank to turn off the solenoid if your tanks pH gets too high or low.

What he said...

If you do some research online you'll see people have varying opinions on the low setting. I think that the low setting may also vary on the type of media being used. What sort of media were you planning to use? Personally I have coarser media and I have my low set at 6.5 and my high at 6.7 for the reactor probe.

There's a pretty good write up on here somewhere that I used when I was setting up my Ca reactor. Maybe someone on here can help you locate it.

 

[snowmansnow]

My media is the reborn... Great stuff