Electrical Assistance Needed...

[j_b_]

I have some GLO T5HO end caps that I'm trying to wire a new ballast to, since the old one died on me.

I picked up a Phillips Advance Certium ICN-2S54 120V to 277V 50/60HZ ballast to replace the old one, and cannot seem to figure out how to wire it. I'm probably just being thick...:confused2:

Anyway, the GLO end caps each have a black/white wire coming from them (total of 8 wires...4/black, 4/white), as seen in the pic below. The ballast shows 6 wires (2/red, 2/yellow and 2/blue), and a jumper, again, pic below.

If anyone can assist in making sure I hook this up correctly, I'd greatly appreciate it! Thanks, in advance.

JB

alt="" />

alt="" />

alt="" />

alt="" />

 

[billsfan]

On one side of the first lamp the black and white wire each connect to a blue wire. On one side of the second lamp the black and white wire each connect to a red wire. On the other side of the lamps connect the white wires of both lamps together and each black connects to a yellow wire.

 

[j_b_]

Thanks for the reply...I was thinking that, but it just didnt seem right, and I just needed some confirmation.

Sent from my SGH-T999L using Tapatalk