JBJ auto top off sensor question

[containerman1]

Has any one ever replaced the float sensor for the jbj auto top off?
I noticed my sensor was sticking and I wanted to just replace the sensor. Seems like everyone has the whole set up but not just the sensor. I found a couple of other float sensors but I would have to cut the cord that I have to tie into the sensor and I would rather but one that plugs into the unit.

 

[porpoiseaquatics]

I have a jbj too (and a full spare) but never had to replace one. so tagging along.

 

[containerman1]

porpoiseaquatics;874910 wrote: I have a jbj too (and a full spare) but never had to replace one. so tagging along.

Found one. http://www.jbjnanocubes.com/contents/en-us/d754_jbj-ato.html">http://www.jbjnanocubes.com/contents/en-us/d754_jbj-ato.html</a>
I am using 2 sensors per auto top off . One in the sump and one in the holding tank
Some how 1 sensor in my sump was not going off and my water was very low until I noticed it.

[IMG]http://www.jbjnanocubes.com">www.jbjnanocubes.com</a>