Mp10w QD not sticking to Red Sea 8mm glass?

joshainga

Active Member
Market
Messages
162
Reaction score
53
So I just swapped out my biocube 32 led for my Red Sea nano I’ve had sitting in my garage still in the box. So I went to put my mp10 on and the dry side keeps coming off when I start it up. It shows the glass tolerance is 9.5 mm and the tank is only 8mm. Any ideas?
 
I’ll try that. I tried 2 different wet sides with the same outcome. I had the one that I was using in my biocube and then one I had still in the box from after I cleaned it and swapped them out a month or 2 ago. But maybe that’s all it is. It held fine on the biocube but maybe with the thicker glass it’s just not getting as strong of a contact.
 
Back
Top