Need help plz

[jbadd99]

http://www.reefcentral.com/forums/showthread.php?t=2434057">THIS LINK</a> may be of some interest to you.

That said, it looks like a Bubble Blaster should hook right up to it. The connectors/size look just like my Reef Octopus Extreme 200. Coralvue also makes an adapter for some models where the connector to the skimmer is larger. I think have one if you wanna give it a go for a BB.

 

[reefstinger]

jbadd99;1076611 wrote: http://www.reefcentral.com/forums/showthread.php?t=2434057">THIS LINK</a> may be of some interest to you.

That said, it looks like a Bubble Blaster should hook right up to it. The connectors/size look just like my Reef Octopus Extreme 200. Coralvue also makes an adapter for some models where the connector to the skimmer is larger. I think have one if you wanna give it a go for a BB.[/QUOTE]

sent u a message

 

[reefstinger]

question guys/gals , when I measure my gray male end threaded size of the vortex housing, its 2" so it must be a 1-1/2 hookup to the female on my skimmer body, does this sizing seem correct, so could I get a adapter to fit a Bubble blaster 1-1/4" coupling

 

[grouper therapy]

Looks like a 1.25" to me.

 

[reefstinger]

grouper therapy;1076655 wrote: Looks like a 1.25" to me.

it measured inside diameter 1-3/4" , I guess I will order the bubble blaster hy 5000s and its 1-1/4: if that want fit I will have to find some way to mod it from 2" to 1-1/4", there isn't much lip coming out of the skimmer bottom female coupler if I cut it and glue on a diff size

 

[grouper therapy]

You need to measure the pipe that goes through the body of the skimmer. either ID or OD

 

[grouper therapy]

That may even be 1" pipe.

 

[grouper therapy]

What is the outside diameter of the pipe coming off of the volute?

 

[grouper therapy]

I might could repair the pin wheel for you.

 

[reefstinger]

grouper therapy;1076689 wrote: I might could repair the pin wheel for you.

yes the pinwheel slides out of the motor block housing towards the from and stops inside the front of the volute. Ill see if I can send it to you USPS , message me your address

 

[jbadd99]