Who cuts glass in the Aplharetta area?

[knightmetro]

I need someone to cut an inch or so off three existing baffles, and make me a new one. Lowes doesn't have thick enough glass.

Who sells and cuts glass in the Alpharetta area? I need three pieces modified, and one pane and custom cut.

 

[glxtrix]

I don't know, but I cut cheese here in Atlanta :blush:

Sorry...had to.

 

[knightmetro]

If my tank didn't stink enough...

Today was sushi day.....give me 15 minutes and the 16th floor will need to call FEMA.

 

[glxtrix]

.......:lol2: That's awesome!

 

[dustin]

Diamond Glass Company in Alpharetta, I used these guys twice now and everything worked, would go back. They are off Kimball Bridge, west of 400.

 

[knightmetro]

Ha. Dig the avatar.

I'll look them up and drop by. What were their prices like?

 

[nassar0505]

Yup diamond glass, will help you with anything glass related. Nice people!

 

[dhmx220]

I used Diamond Glass company. They did a great job and also made some adjustments that I needed, only thing is its pretty expensive. Like 10 dollars a square foot. I bought 5 pieces of glass for a 15 gallon sump and it cost 50

 

[knightmetro]

I just need them to do a one square foot panel and chop 2.5" off 3 baffles I already have.

 

[acroholic]

KnightMetro;829273 wrote: I just need them to do a one square foot panel and chop 2.5" off 3 baffles I already have.

You could do that yourself pretty easily. Buy a $5 glass cutter at Lowes or HD. Simple score and break. Use sandpaper to smooth the edge.

But if you want to have it done, I have been to this place several times over the years in Roswell. They are about 1/4 mile North of the Alpharetta Hwy/Hembree Rd. intersection. Good work and reasonable prices. They sometimes run service calls, so call before you go to make sure someone is there.

Ben-Son Glass and Mirror Roswell.
11220-C Alpharetta Hwy.
Roswell, GA

(770) 663-9992

 

[dhmx220]

Are you using 1/4 or 1/8 glass? I highly reccomend 1/4.

 

[sts04c]

Lowes will also cut glass at some stores.

 

[knightmetro]

I checked Lowes. They don't have the eqip to cut my 1/4 glass and they don't sell anything near that thick.

same thing with acrylic. Not thick enough either.

 

[porpoiseaquatics]

dustin;829202 wrote: Diamond Glass Company in Alpharetta, I used these guys twice now and everything worked, would go back. They are off Kimball Bridge, west of 400.

+1 on Diamond...they do great work!

 

[knightmetro]

Went to Diamond Glass. Great work. Fast, easy, and clean edges.

I had them do a 1/2 panel at 13x17.25 and it cost just over $11. Had to come back in and get it shaved, due to my own mis-measurement, and they fixed it for free in about 60 seconds.

Great place.

 

[nassar0505]

Yup good company! glad it worked out.