Koralia Evo Not Restarting

[brianjfinn]

I just cleaned my Koralia, soaking the drive shaft and the forward part of the housing in a bleach solution, rinsing, and drying. Now, during it's cycle on the wave maker, it won't come on. I've got two others on the wave cycle that I cleaned the same way, and they both work fine. The one that doesn't work will start if I reach in there and spin the drive shaft to start it, but once it turns off, it won't start up again. Any thoughts?

 

[falos]

mine do that wen the rod gowing through the motor has stuf in the hole sand usuly or was put on to tight pressing it past the locks take it back apart and realine it

 

[brianjfinn]

That doesn't seem to be the issue. I made sure there wasn't anything obstructing the drive shaft, and with the new Evolution series, I'm not sure if it's possible to push it in too far.

Anyone else having issues with their Koralias like this?

 

[smallblock]

I thought there was a fix for this, can't remember pm jenn at imagine ocean she was the one that knew.

 

[chris s]

I had that happen a few times. The o ring inside the motor housing wasn't seated and prevented the bushing from going in far enough. Also make sure the prop is on the shaft properly. It will fit in several positions but only slides on fully in one place.

 

[brianjfinn]

Chris S;665883 wrote: I had that happen a few times. The o ring inside the motor housing wasn't seated and prevented the bushing from going in far enough. Also make sure the prop is on the shaft properly. It will fit in several positions but only slides on fully in one place.

Thanks, I'll give this a shot.

 

[jead85]

 

[brianjfinn]

jead85;666277 wrote: http://www.atlantareefclub.org/forums/showthread.php?t=48311">http://www.atlantareefclub.org/forums/showthread.php?t=48311</a>[/QUOTE]

Ha! And I was the second one to reply to that thread. :doh:

Guess I should practice better due diligence.

 

[jead85]

Haha I didn't notice that.