A couple of months ago I purchased a dual line TDS monitor from HM Digital. Since purchasing the item, it has sat in the package because I’m not exactly sure how to set the thing up properly. Although it doesn’t exactly seem like rocket science, I want to make sure I get it done right. Could someone please post a couple of pictures of how the monitor and lines are supposed to look while set up. I guess I don’t need to say it but I’m not the most mechanically inclined person. Thanks in advance.
TDS question
- Thread starter putemup
- Start date
- Messages
- 1,712
- Reaction score
- 0
does it have the T fittings with it?
- Messages
- 1,712
- Reaction score
- 0
the in side connects in between the ro and the di unit, the out is connected on the output side of the di, the last stage, the fittings should be push in
Here is a bad picture of how the "Out" tee is connected to the output of the DI. It is just to the right of the DI and the blue lead goes to the meter which is behind the DI canister. The "In" tee isn't visible but it attaches the same way to the line going into the DI. So cut the out line and just push them into the top of the tee. If this doesn't help send me a PM with your number and I'll give you a call and talk you through it.
Hey thanks man that picture shed so much light on what I'm supposed to be doing here. I had no idea I needed to actually split the lines. I was beginning to assume that you simply attached the meter to test the water then remove it once you have your readings. I was lost prior to seeing you pic. Thanks.
Similar threads
