MP40 wireless master/slave settings

[gregoryleonard]

I have a question for those members that are using MP40 Wireless units as Master/Slave. I downloaded the user manual and reset each unit, assigned the Master (correct colors were displayed), then set the slave (correct colors were displayed) per instructions, but when I go into ecosmart mode (Tidal swell mode) according to the manual, the slave should be orange, but it's white and mimicks the master. I thought it was supposed to be anti-synch in the EcoSmart (TSM) mode. Master and Slave are at opposite sides of the 125 gal DT. What am I missing here?
Thanks for any advice anyone can give. I will also check out their website and see if there are FAQs available on the subject.

 

[cbj25]

You have to change the slave to antisync. Have you looked in the manual in the antisync section?

 

[gregoryleonard]

cbj25;815546 wrote: You have to change the slave to antisync. Have you looked in the manual in the antisync section?

Went to the website and was able to get my answer from FAQs. Just in case someone else needs to know, once you have set up the master/slave modes and start operation, if your pumps are on opposite sides of tank, tap the "Mode" key once and it changes to Orange (anti-Synch mode). Huge difference when you get it right!
Thanks for the direction, steered me in the right direction.