Vics CD 180G Peninsula

Picked up some t5 retrofit from @Jayo , but I wanted to use the euroquatics led bulbs. Unfortunately the fixture t5s had the bulbs angled at a 45degree angle out from center, which would be okay if you’re using a standard t5, but the LED t5s were a single direction.

So, I had to removed the old end caps, bought some generic ones from Amazon. I went with non-waterproof ones because I need it more narrow to fit on the fixture itself. I run my lights 18” off the water in open air, so I don’t think it will be an issue. I’ll inspect it in a few months to confirm.

Meanwhile, the endcaps of the fixture were steel vs the body was aluminum so there was a lot of rust. I had to sand it down and paint it.

In the end, lights turned out great. I’ll get it mounted later this week. I’ll get some aluminum flat bars and cut it to length as needed.
 

Attachments

  • IMG_7465.jpeg
    IMG_7465.jpeg
    120.8 KB · Views: 24
  • IMG_7461.jpeg
    IMG_7461.jpeg
    136.6 KB · Views: 18
  • IMG_7462.jpeg
    IMG_7462.jpeg
    142 KB · Views: 16
  • IMG_7463.jpeg
    IMG_7463.jpeg
    145 KB · Views: 18
  • IMG_7464.jpeg
    IMG_7464.jpeg
    153.8 KB · Views: 19
  • IMG_7468.jpeg
    IMG_7468.jpeg
    283.6 KB · Views: 19
  • IMG_7470.jpeg
    IMG_7470.jpeg
    103.1 KB · Views: 18
Back
Top